So I try to put on my driveshaft on today and another bad thinghappens to me

[mkii_84 at yahoo.com (Andrew Wong)]

Yeah thats what it is.  I think though it was the
grease making it hard for me to adjust.  It was pretty
tight on it.  
--- Robbie Cotner <robw_z@yahoo.com> wrote:
> If I'm following right and you mean the inner CV
> bolt holes are offset from the plate attached to the
> inner CV boot; just remove it, align them and make
> sure the plate is on tight.  When this happens to me
> I can just align them while in the car, but sounds
> like yours are a bit tighter.  HTH,
>  
> -Rob
> 
> Andrew Wong <mkii_84@yahoo.com> wrote:
> The part where the inner CV is supposed to mount on
> to
> the tranny I was able to get, but the holes where
> the
> bolts go in moved slightly in the inner CV, I don't
> think this will sound right, but here goes. The
> Inner
> CV contains two metal pieces with holes in them so I
> could slide the bolt in it, but one of the metal
> plates moved slightly making the bolt to get in the
> CV, not fit in all the way since when I insert it
> in,
> some metal of the other part of the inner CV is in
> the
> way. Its in the scirocco right now, but I can't get
> tbe bolts in because of this. 
> 
> =====
> -Andrew Wong 
> 1984 Black Scirocco
> 1987 White Quantum wagon
> 
> __________________________________
> Do you Yahoo!?
> Yahoo! Calendar - Free online calendar with sync to
> Outlook(TM).
> http://calendar.yahoo.com
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 
> ---------------------------------
> Do you Yahoo!?
> Free online calendar with sync to Outlook(TM).


=====
-Andrew Wong 
1984 Black Scirocco
1987 White Quantum wagon

__________________________________
Do you Yahoo!?
Yahoo! Calendar - Free online calendar with sync to Outlook(TM).
http://calendar.yahoo.com