JE Pistons & block assembly

[flaatr@yahoo.com (Euroroc II)]

So what your saying Shawn is that second or two of non lubricated sliding=20
is enough to seat? Seems kinda short but I don't know either way...

-Raffi


At 05:48 PM 2/25/2003 -0800, Shawn c Meze wrote:

>The answer is in your question.
>All I know is, the 3 motors I built with total seal rings, 2 of them were
>assembled dry and they worked fine. The first one that I built, I did the
>old lube up the cyl walls trick and the rings never seated. Low
>compression ect. The bottom line is, they must be assembled dry for then
>to seat properly. Im told by one of the former owners that this is the
>main reason Velocity stopped using them. (Cant believe im siding with
>Christopher on this one. damn...)
>
>
>Shawn M=E9ze
>86' Jetta GLi 8V   88' Corvette -AS- #30  2002 SDR Solo2 Champion
>Scirocco" 84' Scirocco 8V 82' Scirocco RIP 80' Scirocco S 79' "Project
>FSP
>The Fastest, Quickest, Cleanest and best looking Scirocco(s) in all of
>San Diego!
>http://www.Geocities.com/MotorCity/Speedway/1308/index.htm
>
>
>________________________________________________________________
>Sign Up for Juno Platinum Internet Access Today
>Only $9.95 per month!
>Visit www.juno.com
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l