HELP! Couple of tranny questions...

[roclist@accessconsulting.ca (Jason Adams)]

Check you alignment at the place where the splined end of the long rod that
attaches to the bottom of the shifter clamps to the bracket that holds the
shift ball.  That is where you adjust side to side alignment. If you're out
by one spline you may loose one side of the shift range...

Can you shift into Reverse?

Jason Adams
Fahrvergnugen Forever! ;)
84 rocco 16v
93 320i
98 Z71

----- Original Message -----
From: "Jason Rinne" <rinne_jason@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Thursday, February 06, 2003 10:02 AM
Subject: HELP! Couple of tranny questions...


> Hey All,
>
> So, my tranny in my 82 is not wanting to go into
> 1st gear. No grinding or funny noises and my clutch
> seems to be engaging well, so what's the deal? I installed
> a tt short throw lever and replaced the rubber bushings around
> that area but not the bushings at the tranny. Could that be
> all it is? I imagine a tranny fluid change would be in order
> as well. Another detail, when the car is jacked up and I
> start it out of gear the wheels spin. I can stop them easily
> with my foot, but I thought this to be really strange.
>
> Thanks,
> Jason Rinne
>
> _________________________________________________________________
> Protect your PC - get McAfee.com VirusScan Online
> http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>