Need help again with putting driveshaft in

[rocco16v at netzero.net (L F)]

are you sure you have the correct shaft?  more particularly the right SIDE?

Larry
sandiego16v
  ----- Original Message ----- 
  From: Andrew Wong 
  To: scirocco-l@scirocco.org 
  Sent: Monday, August 04, 2003 11:40 AM
  Subject: Need help again with putting driveshaft in


  I tried again to get my driveshaft in my scirocco and
  am having problems putting it back in.  First I would
  put the bolts on from the inner CV's, but the end of
  it frrom where I put in the axle nut would not reach
  and was too short.  I unscrewed the inner CV bolts and
  tried it from the other way, and then tightened the
  axle nut slightly and the other end would not reach in
  the inner CV's.  THe ballbearings also kept comming
  off, the innter CV.  I could not get it to screw in. 
  Should loosen the axle nut a little more and try to
  put it back in?

  Also I think in my Quantum my intank fuel pump is
  cauing me problems.  At start up it wants to stall,
  but after a while the idle levels off back to the
  normal idle.  But I hear buzzing noises.  I saw the
  the tutorial on ATS's site and it doesn't look hard. 
  Is it an easier job than Changing a driveshaft?

  =====
  -Andrew Wong 
  1984 Black Scirocco
  1987 White Quantum wagon

  __________________________________
  Do you Yahoo!?
  Yahoo! SiteBuilder - Free, easy-to-use web site design software
  http://sitebuilder.yahoo.com

  _______________________________________________
  Scirocco-l mailing list
  Scirocco-l@scirocco.org
  http://neubayern.net/mailman/listinfo/scirocco-l