one more thing.. poly front mount

[treed2@u.washington.edu (T. Reed)]

Forgot to put this in my last message..

After aligning the mounts, I revved the engine (it sure shakes a lot more
now that its not shaking the large mass of the chassis with it) and
noticed that my poly front mount is moving inside the cup, ever so
slightly.. about 1-1.5mm. I'm concerned that this could have a
"hammering" effect on the crossmember over a long period of time,
especially given the "spirited" manner in which I drive.

I think I remember reading that polyurethane "dents", is this correct? If
so, should I get a new poly mount ($10?) since the one I've got seemed to
have been crushed slightly (maybe because it was bearing engine weight??).

-Toby