For inner CV joints, I use a triple square and thats 12 point?

[mkii_84@yahoo.com (Andrew Wong)]

I went to Discount and Autozone to look for the 12
point/ triple square, they did not have it.  I checked
NAPA, but it was before I knew I could call it the 12
point internal drive bits.  I said triple square and
got wierd looks.  I might check NAPA again when i go
home from school when spring break ends since I drive
it everyday
--- Robbie Cotner <robw_z@yahoo.com> wrote:
> yes, you use a 12point/triple square.  I also went
> through a lot of funny looks when asking around for
> a "triple square", eventually I gave up and ordered
> a set online.  However, now I see that they were in
> the parts stores I went to, but there they are
> called "12 point internal drive" bits.  If I
> would've asked for those, I may have actually gotten
> them much easier!  You may just have to go to the
> tool section and look for them.  Specifically I got
> my second set at Carquest, but have seen them at
> NAPA too.  HTH, -Rob
> 
> Andrew Wong <mkii_84@yahoo.com> wrote:I use a 12
> point rather than a 6 point? I also went
> to the autostore looking for a triple square and no
> one knew what that was. 
> 
> =====
> -Andrew Wong 
> 1984 Black Scirocco
> 1987 White Quantum wagon
> 
> __________________________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo
> http://search.yahoo.com
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
> 
> 
> ---------------------------------
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.


=====
-Andrew Wong 
1984 Black Scirocco
1987 White Quantum wagon

__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com