[TECH] Side Draughts with Carbs

[green536@hotmail.com (Chris DeLong)]

The key is in the jetting, not in the diameter of the carbs. and the 3a 
block is 1984cc not 1948cc. probably jsut a typo but I thought I would point 
it out.



Chris DeLong
Fine Tuning
206.367.5503
Seattle, WA USA





>From: "ATS - Patrick Bureau" <txrocco@sbcglobal.net>
>To: "T Berk" <tberk@mindspring.com>
>CC: <scirocco-l@scirocco.org>
>Subject: RE: [TECH] Side Draughts with Carbs
>Date: Sun, 6 Apr 2003 12:41:22 -0500
>
>Correct me if I am wrong but displacement is based on the amount the 
>pistons
>can hold, so since I am using a 3A block (1948cc) then I am looking for
>weber 45 carbs then?
>
>ATS - Patrick Bureau - txrocco@sbcglobal.net
>
>
>=>-----Original Message-----
>=>From: T Berk [mailto:tberk@mindspring.com]
>=>Sent: Sunday, April 06, 2003 5:33 AM
>=>To: ATS - Patrick Bureau
>=>Cc: scirocco-l@scirocco.org
>=>Subject: Re: [TECH] Side Draughts with Carbs
>=>
>=>
>=>It's gotta be based on the total displacement, not the head itself.
>=>
>=>TBerk
>
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l


_________________________________________________________________
The new MSN 8: smart spam protection and 2 months FREE*  
http://join.msn.com/?page=features/junkmail