durability of JH block internals and going turbo

[jdbubb@ix.netcom.com (Dan Bubb)]

Perhaps.
But I only said I thought they are the same length to answer Jeff's
question of changing CR by swapping rods.
Also, pin diameter could be different and they could use bolts instead
studs and nuts.
Didn't think any of that was really relevant to the question.
Dan
PS. rifle!



Marc scirocco Qu=E9bec wrote:
>=20
> Aren't the 3A Audi rods riffle drilled?
>=20
> And the JH'S rods not being riffle drilled?
>=20
> Cheers.
>=20
> Marc
> '83 scirocco
> '88 Scirocco Slegato
>=20
> --- Dan Bubb <jdbubb@ix.netcom.com> a =E9crit : > As far
> as I know the JH and 3A rods are the same
> > length at 144mm center
> > to center. The extra stroke is accomodated by moving
> > the piston pin a
> > little higher in the piston.