[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Head Gasket



dont discount the valve cover gasket. if it leaks by the cam pulley (or the
cam seal itself), it could run around to the back and then down.
Al

----- Original Message -----
From: "Calimus" <calimus@techography.net>
To: "Scirocco ML" <scirocco-l@scirocco.org>
Sent: Tuesday, May 21, 2002 12:13 PM
Subject: Head Gasket


> I finally got around to putting in my new thermostat with extra holes
> lastnight and it seems to have chilled the car out.  I was just about to
> reall go take her for a drive when for some reason I checked the back of
> the engine and noticed some nice fresh oil.  At best it looks as though
> it's coming from right in-between the head and the block, not what I
> wanted to see.  However, this is also the area where the the timing-belt
> cover curls around the backside a bit.  Would my guess of bad head
> gasket be correct in this?  It's not a river of oil pouring out, but
> it's enough to leave a noticable ammount under the car after a drive.  I
> really can't think of where else the oil could be coming from and I'll
> prollie need to take of the timing cover just to get a better look.
> Pointers in this area would be nice.  I almost thought I was going to
> have a rocco to drive to Cincy, however the toyota with A/C is lookin
> purdy nice.
>
> William
> --
> http://www.techography.com/scirocco (s.org forums)
>
> 88' Scirocco 16v (the void)
> 89' Cabriolet 8v (pretty bunneh)
> 71' Karmann Ghia (air sucker)
>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l