removal of fenders

[indiana_red@hotmail.com (Ken Bates)]

Eric,
hit is right about the glue.  When I pulled both off of my 79 I hadn't
thought about a heat gun or torch even.  The glue is kind of like a caulk.
It was a real pain.  Im glad I wasn't trying to save them for a reinstall.
Julie has a good point though too.  I know <78's have the non-wrap around
turns but I would be very surprised that a fender removal is required to
replace a turn signal lens.  My '79 does not.   You have a Bently, (fender
removal instructions)...but does it also say you have to do this too?
Double check.  Like my pappy used to say   "...measure twice...cut once..."
HTH
Ken
'79 Scirocco 16v project "McFly"
'86 16v (parts car)
VORTEX:  "Indiana Red"

----- Original Message -----
From: "Erik Seo" <seowitz@seowitz.com>
To: <scirocco-l@scirocco.org>
Sent: Tuesday, May 14, 2002 1:12 AM
Subject: removal of fenders


> Well i'm just full of questions!
>
> I just got a new front left turn signal for my 77 rocco....
> ok so it seems that I need to remove my fender to get the thing in
> there.....
>
> So after looking at the Bentley, I removed all the screws along the engine
> bay, the one by the grille, the two bottom one's, removed the bumper
screws,
> and then the two in the wheel well on the door side of the wheel well.  As
> far as what I could see, and what the Bently manual said that's it.
>
> Problem is, the damn thing wouldn't move......am I missing something?
>
> Erik
> www.seowitz.com
> www.team-arg.com
>
>
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>