Tranny/Clutch issue

[dan@angband.org (STENDEC)]

On Fri, May 03, 2002 at 02:59:43PM +0000, Ben Smith wrote:

> The little splined lever inside the gearbox case that actuates the clutch 
> push rod on my rocco broke the other day.  I'm not sure what the part is 
> called (neither was the dealership), 

ETKA calls it a "Clutch Operating Lever", I've always called it a clutch
release finger.

> but it is on the shaft that has the 
> clutch cable lever on it.  I ordered the part ($15 + shipping) however I am 
> not sure if installing it is possible without a workshop and tools I don't 
> have.  On either side of it, there are snap rings that are not compatable 
> with my snap ring tool.  If anyone has replaced this part before, please 
> let me know what is involved.

You shouldn't need a special tool to pull that clip off, a regular
screwdriver worked fine for me.

Dan


-- 
Even in a Benji lunchbox, grain alcohol is a pretty manly drink.

		-- Grant T. Michalski