je design rear fill plate

[cory.langford@icbc.com (Cory Langford)]

If I remember correctly, the best thing I have seen in pictures is to
either mount it directly to the back piece of the body kit (evasive), or
I have seen the front bumper plate holder mounted upside down, under the
rear bumper.  This requires a couple holes in the underside of the
bumper to bolt the plate holder to.

Other than that, there is always duct tape to the rear window ;)


-- 
Cory Langford
'86 Oettinger turbo project
'83 beater 


-----Original Message-----
From: breandan mcilwain 
Sent: Tuesday, April 30, 2002 7:57 PM
To: scirocco list
Subject: je design rear fill plate


i have this for my roc and i want to keep it on all
the time, problem is i dont know where to mount the
licence plate.  i need the plate of course to drive
the car around, so any non evasive ideas that i could
use to mount the plate?(dont wanna drill hole)
thanks
breandan