Replacing the black vinyl on the Deck and B-Pillar

[flaatr@yahoo.com (Euroroc II)]

Me neither... that's why I only replaced a small section and was planning 
on leaving it on for a month or two to see how it looks and if it peals... 
So far it looks great

-Raffi


At 03:59 AM 3/27/02 -0500, you wrote:
>On Wed, Mar 27, 2002 at 12:42:45AM -0800, EUROROC II wrote:
>
> > So I'm not done with my test and I can't give you my advise on how to
> > remove the old stuff and prep the area but I'm getting so many emails I
> > decided to get the roll and tell you all what I used.
> >
> > It's made by Rubbermaid. the label reads as follow
> >
> >       Rubbermaid
> >       Con-Tact Brand
> >       Ultra Covering
>
>Hrm.. not sure how con-tact paper is going to stand up to UV damage and
>such.  When I replaced the vinyl on my 16v B pillars, I used a product
>from 3M designed to protect the leading edge of aircraft wings from
>abrasion damage.. go to Aircraft Spruce and search for "Leading Edge
>Tape"  It costs some bucks, but it comes on a 100 foot by 6" wide
>roll.  Luckily, I had some kicking around the hangar so it cost me nuthin.
>
>Dan
>
>--
>It isn't pollution that's harming the environment. It's the impurities in
>our air and water that are doing it.
>
>                 -- Dan Quayle
>
>_______________________________________________
>Scirocco-l mailing list
>Scirocco-l@scirocco.org
>http://neubayern.net/mailman/listinfo/scirocco-l


_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com