power windows to manuel windows

[amalventano1@comcast.net (Allyn)]

    you can go from manual to power easily, everything bolts up, you have to widen the hole in the
panel for the switch. The power switches and manual handles go inthe same place.
    now going from power to manual you will end up woth a hole that is a bit larger than the handle.
you will have to somehow cover that hole.
Al

----- Original Message -----
From: "Euroroc II" <flaatr@yahoo.com>
To: "brett cooke" <vwscir88@hotmail.com>; <Scirocco-l@scirocco.org>
Sent: Monday, March 25, 2002 7:42 PM
Subject: Re: power windows to manuel windows


> Not very if you have both left and right side power window motor assemblies
> and 1 single switch for the passenger side door and a double switch for the
> driver. I think the mount points for the motor and track are in all the
> doors. You will need new door panels for the switches to mount to. Since I
> don't know exactly where the hole for the manual window lift is I can't say
> for sure if they can be modified for the power window switches. The rest is
> wiring.
>
> Some one just had a complete setup on ebay with both motors, the switches
> and all the factory wiring harnesses.... Might come up again.
>
> -Raffi
>
>
>
> At 05:17 PM 3/25/02 -0500, you wrote:
> >how hard is it to convert a non- power windowed door to one with power
> >windows and vice versa?
> >  hit
> >
> >_________________________________________________________________
> >Send and receive Hotmail on your mobile device: http://mobile.msn.com
> >
> >
> >_______________________________________________
> >Scirocco-l mailing list
> >Scirocco-l@scirocco.org
> >http://neubayern.net/mailman/listinfo/scirocco-l
>
>
> _________________________________________________________
> Do You Yahoo!?
> Get your free @yahoo.com address at http://mail.yahoo.com
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l