Front Lower Stress Bar bolt Pattern?

[roclist@accessconsulting.ca (Jason Adams)]

The Rear mounting points go on top... Uh.. oops.

I mounted them on the bottom, cause thats how I though they went.... Man I
was wondering why I had to grind away some of the body to got them to fit...
Oh well, Seem to work fine for me...

You could maybye modify a "C" clamp to have one part come to a point, Heat
up the area in question and try to "dent" the area for the hole. But I like
that airplane thingy better...


> On Wed, 12 Jun 2002, Dan Baisley wrote:
>
> > On Wed, Jun 12, 2002 at 07:35:13AM -0400, Rick Kellner wrote:
> > >   I picked up a stock, front lower stress bar from a 16v Scirocco that
I
> > > want to put on my 84 8v.  Since this was not a stock component for my
car I
> > > will need to drill two holes for the back mounts.  Since the bar
mounts on
> > > top there is no way to drill accurately from the bottom.
> > >        Does anyone have a diagram they could scan or fax showing the
bolt
> > > pattern?  Any suggestions?  Thanks Rick Kellner.