[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
machined part needed
-----Original Message-----
From: scirocco-l-admin@scirocco.org
[mailto:scirocco-l-admin@scirocco.org] On Behalf Of Shawn C Meze
Sent: Wednesday, June 05, 2002 1:00 AM
To: roccolister@hotmail.com
Cc: scirocco-l@scirocco.org
Subject: Re: machined part needed
On Tue, 04 Jun 2002 21:00:46 -0700 "Craig Williams"
<roccolister@hotmail.com> writes:
>
>Scott,
>
>Why not just bolt up a distributor to plug the hole? Cut the rotor
>shaft dow=20
>and make a cap of some sort to cover it all and it won't look like a=20
>distributor.
>
>-- Craig
Umm, this might be a stupid question but, why not just get a stock 16v
block off plate? Hmm? I mean.....=20
Shawn M=E9ze
86' Jetta GLi 8V 88' Corvette -SS 30- 2001 SDR Solo2 Champion
82' Scirocco GTi -FSP 54- 79' "Project FSP Scirocco" 84' Scirocco 8V
The Fastest, Quickest, Cleanest and best looking Scirocco(s) in all of
San Diego! http://www.Geocities.com/MotorCity/Speedway/1308/index.htm
Because Scott is talking about the 16V distributor on the side of the
head.
I'm pretty sure you are talking about the little disc that goes on the
block, where the 8V distributor bolts up.
Peter