how to unsubscribe

[angus6@socket.net (Bob & Ann)]

> Well, I DID that and I'm still on the list!!!
> :)
>
> Larry  sandiego16V
Larry please check what what model number your Evaporator is, if it's model
number 21 thru 26 it's on the recall list, Please return it to place of
purchase at once so it can be updated with a new model

> > >> HOW TO UNSUB FROM THIS LIST YOURSELF
> > >
> > >
> > > First, ask your Internet Provider to mail you an Unsubscribing Kit.
> > > Then follow these directions.
> > > The kit will most likely be the standard no-fault type. Depending
> > > on requirements, System A and/or System B can be used. When
> > > operating System A, depress lever and a plastic dalkron unsubscriber
> > > will be dispensed through the slot immediately underneath. When you
> > > have fastened the adhesive lip, attach connection marked by the
> > > large "X" outlet hose. Twist the silver- coloured ring one inch
> > > below the connection point until you feel it lock.
> > > The kit is now ready for use. The Cin-Eliminator is activated by
> > > the small switch on the lip. When securing, twist the ring back to
> > > its initial condition, so that the two orange lines meet.
> > > Disconnect. Place the dalkron unsubscriber in the vacuum receptacle
> > > to the rear. Activate by pressing the blue button.
> > > The controls for System B are located on the opposite side. The red
> > > release switch places the Cin-Eliminator into position; it can be
> > > adjusted manually up or down by pressing the blue manual release
> > > button. The opening is self- adjusting. To secure after use, press
> > > the green button, which simultaneously activates the evaporator and
> > > returns the Cin-Eliminator to its storage position.
> > > You may log off if the green exit light is on over the evaporator .
> > > If the red light is illuminated, one of the Cin-Eliminator
> > > requirements has not been properly implemented. Press the "List
> > > Guy" call button on the right of the evaporator . He will secure
> > > all facilities from his control panel.
> > > To use the Auto-Unsub, first undress and place all your clothes in
> > > the clothes rack. Put on the velcro slippers located in the cabinet
> > > immediately below. Enter the shower, taking the entire kit with
> > > you. On the control panel to your upper right upon entering you
> > > will see a "Shower seal" button. Press to activate. A green light
> > > will then be illuminated immediately below. On the intensity knob,
> > > select the desired setting. Now depress the Auto-Unsub activation
> > > lever. Bathe normally.
> > > The Auto-Unsub will automatically go off after three minutes unless
> > > you activate the "Manual off" override switch by flipping it up.
> > > When you are ready to leave, press the blue "Shower seal" release
> > > button. The door will open and you may leave. Please remove the
> > > velcro slippers and place them in their container.
> > > If you prefer the ultrasonic log-off mode, press the indicated blue
> > > button. When the twin panels open, pull forward by rings A & B.
> > > The knob to the left, just below the blue light, has three settings,
> > > low, medium or high. For normal use, the medium setting is
> > > suggested.
> > > After these settings have been made, you can activate the device by
> > > switching to the "ON" position the clearly marked red switch. If
> > > during the unsubscribing operation, you wish to change the settings,
> > > place the "manual off" override switch in the "OFF" position. You
> > > may now make the change and repeat the cycle. When the green exit
> > > light goes on, you may log off and have lunch. Please close the
> > > door behind you
> >
> >
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
>
> ----------------------------------------------------
> Sign Up for NetZero Platinum Today
> Only $9.95 per month!
> http://my.netzero.net/s/signup?r=platinum&refcd=PT97