[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Will a little JB Weld help this??
Replace the rear main seal on the engine, and the push rod and input shaft
seal on your tranny.
It's also not a bad idea to change the output cup seals while the tranny is
out of the car. However you will a special tool to do those.
----- Original Message -----
From: "Patrick Downs" <patrickvr6@mindspring.com>
To: "Scirocco (E-mail)" <scirocco-l@scirocco.org>
Sent: Sunday, February 10, 2002 4:32 PM
Subject: Will a little JB Weld help this??
> Well I got my shift linkage parts on Thursday and went to put them on my
car
> today to try to sort out my tranny issues. When I started crawling around
> under the car I noticed this http://66.47.100.223/images/hole.jpg. So I'm
> pretty sure I will be needing a new tranny after all. On a positive note
I
> did wax most of the car and the paint looks pretty decent.
> http://66.47.100.223/images/front.jpg http://66.47.100.223/images/side.jpg
> Here are the "before" shots. http://66.47.100.223/scirocco I am
planning
> to replace the clutch and put in a lightened flywheel when I swap the
> tranny. Anything else I should do while I'm in there?
> Patrick
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>