more tranny crap from me

[thescirocco@juno.com (thescirocco)]

---------- Tony Morehead <wolfsburg16v2k2@yahoo.com> writes:

still working on the agb, but slowly because i have exams to study for : (    anyway, i cannot get the old oil seal to come out on one side.  prying with a crow bar just folds the innner part out a little and i am afraid of putting too much force in and scratching the inside so the new one wont seal.  how should i go about removing it?

TIA,

-tony

A crow bar should work, as long as it's small enough, I prefer using a pry bar, and I use the trunion shaft as the fulcrum point.

Sometimes it can take quite a bit of pressure to pop them out.

You can also cut and peel the seal out with diagonal cutters.

HTH!

Peter



PLEASE REPLY TO: peterSPAM@thescirocco.com hold the SPAM and you have my new e-mail address.[mailto:peterSPAM@thescirocco.com]
Please don't reply to the Juno account, and if you must - don't expect a reply.


________________________________________________________________
Sign Up for Juno Platinum Internet Access Today
Only $9.95 per month!
Visit www.juno.com