MKI stock weight bias

[amalventano1@comcast.net (Allyn)]

ben,
    got this from larry, but its from a mk2:

-Al
-Toolbox weight is 23.5lbs. (I weighed it just now), it's center of mass was
-about 6 inches from the left rear shock tower (towards the centerline of the
-car) and about 10 inches to the rear of the tower. It had half a tank of
-fuel (the 20lbs I had down before was an estimate of the toolbox, not the
-gas load) Individual wheel weights:
-LF 758      RF 774
-LR 401      RR 478
-Larry

hth,
Al
----- Original Message ----- 
From: "Ben Beacock" <bennyb2k4@sympatico.ca>
To: "Scirocco. org Mailing List" <scirocco-l@scirocco.org>
Sent: Wednesday, August 21, 2002 1:55 PM
Subject: MKI stock weight bias


> I'm working on making a 3D model for a racing game and I'm looking for
> the following spec:
> 
> CofG location:  If I have the front/rear weight bias, I could figure it
> out from that.  I checked driversfound.com and the brochure/stats don't
> mention it.  Maybe a car&driver article has it?
> 
> 
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l