Bilstein install help please

[Scirocco-Al" <scirocco-Al@insight.rr.com (Scirocco-Al)]

This happened with my last set of  Koni's.  It was so bas that I eventually
gave up on getting it apart in a normal fashion and started cutting the
housing in two lengthwise with my angle grinder.  Of course I got about 3"
inched from cutting the thing all the way apart and the seal on the sturt
blew, sending oil into my face.

Lots of fun.

Alan
----- Original Message -----
From: "Rick Alexander" <rick@brubakerbox.com>
To: <scirocco-l@scirocco.org>
Sent: Wednesday, April 17, 2002 7:34 PM
Subject: Re: Bilstein install help please


> Generally not a big job. The BFH might distort the strut housing which
will
> only compound my problem. Heat might be dangerous because I don't know if
> this strut is nitrogen charged or not. Even if it isn't it might boil the
> oil out of it and start a nasty fire. Worst case scenario I'll have to get
> another housing. Unfortunately I'm scheduled to AutoX this coming Sunday
and
> I don't want to miss the season opener.
>
> Rick Alexander
> http://www.brubakerbox.com
> http://clubs.hemmings.com/hams/
> http://clubs.hemmings.com/vwsrus/
>
> ----- Original Message -----
> From: "Josh Hignight" <Josh.Hignight@phoenix.edu>
> To: "'Rick Alexander'" <rick@brubakerbox.com>
> Sent: Wednesday, April 17, 2002 7:34 PM
> Subject: RE: Bilstein install help please
>
>
> > Heat and BFG are the only things I can think of. There's not a screw/nut
> on
> > the bottom is there (lucky enough to have never done inserts myself).
> >
> > Joshua Hignight
> > Student Services/Technical Services
> > New Mexico Campus
> > (505) 821-4800
> >
> > -----Original Message-----
> > From: Rick Alexander [mailto:rick@brubakerbox.com]
> > Sent: Wednesday, April 17, 2002 5:21 PM
> > To: scirocco-l@scirocco.org
> > Subject: Bilstein install help please
> >
> > I'm refreshing the front of Rolling Roc ('87 16v). I'm installing
Bilstein
> > sport inserts and a 22mm sway bar. I've done this many times but I've
> never
> > had a strut cartridge refuse to come out of the carrier. The retaining
nut
> > is off. I've re-installed the spring in hopes that it will pull the
insert
> > out but no dice. I don't want to hit it much more for fear of bending
the
> > strut housing. I don't want to put heat on it for the obvious reasons.
Do
> > any of you have another trick to get the strut out?
> >
> > Rick Alexander
> > http://www.brubakerbox.com
> > http://clubs.hemmings.com/hams/
> > http://clubs.hemmings.com/vwsrus/
> >
> >
> > _______________________________________________
> > Scirocco-l mailing list
> > Scirocco-l@scirocco.org
> > http://neubayern.net/mailman/listinfo/scirocco-l
> >
> >
>
>
> _______________________________________________
> Scirocco-l mailing list
> Scirocco-l@scirocco.org
> http://neubayern.net/mailman/listinfo/scirocco-l
>