[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: 2.0 buildup
where can one obtain stabilant-22?
how can one clean connections when sandpaper cant get there?
koabi
-----Original Message-----
From: owner-scirocco-l@scirocco.org
[mailto:owner-scirocco-l@scirocco.org]On Behalf Of T Berk
Sent: Tuesday, October 09, 2001 11:09 AM
To: koabi brooks
Cc: scirocco-l@scirocco.org
Subject: Re: 2.0 buildup
koabi brooks wrote:
>
> ok, i have the motor, and tranny now in my car. now what?
Pour about a tablespoon of motor oil in each cylinder and put the plugs
back in. Helps to lube a block that has been sitting awhile.
> redline for the transaxel?
Love it. MTL90.
> should i be using contact enhancer when i plug everything together? if
so,
> what should i use, and where?
You will want a cleaner that leaves a small amount of lube behind after
it cleans. Pros: Cuts future oxidation, Cons: Tends to accumulate grit
and grime, over time. Best heard of so far?: Stabilant-22 (Gotta buy
some so I can try it personally). It's not a cleaner but it's more like
a contact enhancer.
> any other tips as this thing gets assembled?
>
> koabi
> 88 16v running soon (hopefully)
>
> --
Injecter O-Rings, just get new ones.
Basic Tune Up Stuff like filters and cap n' rotor.
Electrical Ground Straps in the Engine Bay; augment, up rate.
Motor Mounts
All Rubber Valve Cover Gasket w/ new studs. Reusable, non leaking.
Uh, that's all for now.
TBerk
--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org