Re: [eng] thinking of changing

["Allyn" <amalventano1@home.com>]

Foxx,
    In response to number 1, you will need an impact and a propane torch.
Heat the center bolt prior to impacting it off. Had to do this over at Eric
Ellis' place a few months back.
Al

----- Original Message -----
From: "Foxx (in a box)" <foxxinabox@copper.net>
To: "scirocco list" <scirocco-l@scirocco.org>
Sent: Saturday, December 01, 2001 6:58 PM
Subject: [eng] thinking of changing


>   i'm not quite sure when my last oil change was, but i'm thinking i'd
> better do it before it gets much colder. before i do this, however, i've
> a couple questions.
>   1) i seem to be leaking from somewhere and it looks like my crank seal
> on the timing belt end. pain in the ass to replace? i have the seal from
> overstock, but from what i understand the crank bolt is a pita.
>   2) i want to get all the gunk out of there when i change the oil.
> ideas? some kerosene mixed in there before i drain it? other things i
> could use instead? thanx.
>
> --
>  /\_/\   Foxx (in a box)
> < o o >   http://foxx.tripod.com
>   \ /
>    °
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org