[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Lower subframe stress bar Q



Mike,
Send it back to Eurosport or the place you bought it from, it's a defective
bar.
Otherwise, put it on E-bay you might even get more for it than you paid for
it. :D
I am also considering the Autotech lower subframe, very nice design that
looks like it actually works.

Randy


> > I bought the Eurosport rear upper strut tie bar and it was almost 1/2"
off
> > (and I know my car isn't).
> >
> > As far as your bar goes (Since it's Eurosport) I wouldn't jump to the
"my
> > car is bent" conclusion yet.
>
> Randy was correct--it's the Eurosport bar that's off.
>
> The spec sheet that came with the bar says the distance from the centers
of
> the control arm bolts should be 26 7/8".  That's pretty much what I
measured
> on my car.  The centers between the mounting holes on the Eurosport bar
> measure 26 9/16".  Argh.  It would've been nice to make that discovery
> *before* I had taken everything apart.
>
> I was going to just grind the mounting holes in the bar to make it fit,
but
> the rear mounting points are also off.  By the time I would've ground out
> enough material for them to line up, there wouldn't be enough material
left
> to really hold anything.  <sigh>  That's too much work for something that
> just won't be right when I'm done.  Looks like I'll take Eric's advice and
> look into the Autotech 4-point bar.
>
> Does anybody want an unused, out-of-spec Eurosport lower stress bar for
> cheap?  :)
>
> Thanks to everyone who responded.
> Mike Carlson
> '84 Scirocco Wolfsburg Edition
> '95 GTI VR6
> http://members.home.net/mikes.vws
>
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org