[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: My new exhaust!



-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Well, taking it out for another drive, I hit a pothole and all the
clunking issues are back like on my first test drive with the
exhaust, so I guess I am going to have to take it all apart again,
and try cutting a bit off the downpipe as you suggest! I hope that
clears things up, because this is getting a bit annoying. I just hope
I didn't tighten the clamps down too tight, making it a real PITA to
get the thing apart again.







The goal is to overcome the deliberate nature of the process. 

> -----Original Message-----
> 
> The rubber hangers won't settle that much... 
> You can adjust the metal hangers on the inlet of the muffler, but
> I'd try tweaking the exhaust first.
> Check the clearances along the entire exhaust, running your fingers
> along it, especially by the over axle part where the heatshield is.
>  
> Move the exhaust around by the tailpipe as you continue to look for
> clearance issues. 
> 
> When I first installed the TT exhaust on my Scirocco, I had some
> rubbing problems, and the tailpipe hanger didn't line up. I called
> TT and Collin said that I probably have an early 16V 2" race
> downpipe, and that it is a little longer. I separated the exhaust,
> cut about an inch off of the downpipe, reconnected it making sure
> it was aligned, and it it doesn't rub at all. 
> 

-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.8 for non-commercial use <http://www.pgp.com>

iQA/AwUBO+HIMgO3tw2TqB1hEQKugwCePxSqM0waqlHUwYHaM73nH/uO5AEAoNps
ku3fSjDIHhsCZyl+Squiyuob
=7IaC
-----END PGP SIGNATURE-----


--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org