Re: lightened flywheel

[Eric L Ellis <elf16v@juno.com>]

There are two 2 dowell 210mm  flywheels that I know of.  The "first"
generation has a smaller amount of material.  The "second" came in the
early A-3's and had a load past the ring gear...I don't know about an
inch.

Either can be lightened equally.

Eric
Good, bad...I'm the guy with the gun!
http://www.geocities.com/blitzkrieg16v/



On Sun, 25 Mar 2001 19:35:29 -0800 "Todd Detwiler"
<todd_detwiler@hotmail.com> writes:
> OK, so, I took the old flywheel out and compared it to my new 
> lightened
> flywheel. I was amazed at how much material had been removed. Nearly
> everything up to the ring gear. Is this normal. I did not get mine 
> from
> Velocity, so I was hoping that someone who did could verify this for 
> me. On
> my old one, there is probably over an inch of material past the ring 
> gear.
> Is it normal to remove that much?
> Thanks,
> Todd
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to 
> majordomo@scirocco.org
> 

________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org