Re: still working on the timing-need HELP!

[Brett Van Sprewenburg <brett@netacc.net>]

>Hello List,
>need help and your expertise in getting my 16v timing
>right. I recently replace my stock cam gear with
>RPI's. belt was not installed correctly so I
>reinstalled cam belt,gear and lower pulley to ZERo
>including tranny mark. Got the engine fired-up, idle
>is fine(no sign of valve damage). However, I still
>somehow cannot get the timing to TDC. cam gear mark
>and lower pulley are aligned 7 to 10 degree on retard
>side. played with Distributor but no improvement. ANY
>INPUT????
>
>Thanks in Advance,
>
>Leo (need to get rocc before ND)
>
>=====
>
>LEO -  87 Scirocco 16V/SFBA-VW/SCIROCCO.ORG

If I read this right...you set everything up at TDC, got
all the marks lined up, and are now noticing things are
moving around again?  If that's the case, you probably have
sheared the crank gear woodruff key.  Take a look there. If
I'm not reading this right...explain it to me again?
==Brett

 \/  '84 Scirocco (ITB racer 2B) | "Hot VW's, take two home. They're small"
\/\/ '88 Scirocco 16v (Show), '92 Passat 16v (Winter+) | - brett@netacc.net

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org