Re: Replacing Strut Bearings

[Eric L Ellis <elf16v@juno.com>]

I installed my poly front bearings without too much trouble.  I unbolted
the front sway bar ends, removed the right side axle (unbolted controll
arm on pass side), and removed the bearings.  Went back together slowly
and I vowed to remove everything and do it the RIGHT way next time.

Eric
Good, bad...I'm the guy with the gun!
http://www.geocities.com/blitzkrieg16v/
request VW parts at
http://www.geocities.com/usedVWparts/



> > Does anyone know if it's possible to replace the front strut bearings
> > *without* altering the alignment?  I have replaced these before, but
> > just was wondering if this could be possible...to save getting
another
> > alignment!  I was thinking if you removed the main bolt from the ball
> > joint that it may allow the control arm to swing down enough...not
sure.
> > So, anyone with this experience?
> >
> > Thanks!
> >
> > =====
> > ____________________________________
> > Benjamin Harder
> > 86 Scirocco 16v
> > 81 Scirocco
> > 80 Scirocco S (picking it up this weekend!)
> >
> > http://www.geocities.com/vwtype53/
________________________________________________________________
GET INTERNET ACCESS FROM JUNO!
Juno offers FREE or PREMIUM Internet access for less!
Join Juno today!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org