Re:NOW stripped mounting [FS] 16V 100mm Drive Shafts complete

[Captnbr@aol.com]

In a message dated 6/27/2001 8:11:51 PM Eastern Daylight Time, DonW@cati.com 
writes:

<< The bolts are stripped.  Any suggestions on fixing this
 problem? >>

If you are talking about the two studs that stick out of the bottom of the 
car on the rear mount.....been there, done that, its a bitch.  Fortunately 
only one of mine was stripped and it was the front one.  it this is it then 
saw off the stud,  drill a hole through the center and put in a new bolt, you 
can drop the new one in from the top.  If the second one is stripped to i 
cant help you because I do not know how you can access it except from inside 
the cabin i guess under neath the center console. Good luck.

Brian 86 Rocco 16v
and 98 Jetta GLX Vr6

<http://www.geocities.com/vwrocco16v/>

<http://hometown.aol.com/captnbr/myhomepage/auto.html>

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org