[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Hot Start Pulse Relay or Lambda Realy - does anybody know more than the Bentley
CHECK IT OUT.
I think the 8v is running again, taking it out for a test in a few minutes.
After all the testing and replacing, I found the 30 pin on the fuel pump
relay loose. I am speculating that the intermitent miss and loading up were
form the pump running and not running. I keep you posted. To all the reply's
thanks.
Brian
88 16v
86 8v ( running better, not kicking my ass as hard)
A Fucking Relay?
----- Original Message -----
From: "Brian Wagner" <scirocco_88_16v@hotmail.com>
To: <scirocco-l@scirocco.org>
Sent: Friday, July 13, 2001 9:53 AM
Subject: Tech: Hot Start Pulse Relay or Lambda Realy - does anybody know
more than the Bentley
> The 8v still has the hesitation, so I pull the HPR and the idle
immediatley
> drops 300 rpm. Per the Bentley this relay is to pulse every 2 seconds
while
> the starter is engaged ( this damn thing is staying on) I assume it is
> feeding extra fuel if it continues to pulse. I haven't driven it yet with
> this disconnected to see if it still hesitates under a load, when I run
the
> idle up in the garage it stumbles slightly and then takes off to 5800 rpm
> (pops a little bit, loads up at 3200 rpm), any help on this would be
> appreciated. TIA
>
> Brian
> 88 16v
> 86 8v (still kicking my ass)
>
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to
majordomo@scirocco.org
>
>
--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org