[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: low beam/high beam question



Koabi,

Sounds as if its either a switch problem or a wiring problem.  

http://mk1scirocco.com/scirocco/tech/_low_beams_with_high_beams/bentley.jpg

Check the white wire that goes from the flasher switch on the stalk to
the fusebox.  If this is loose you may get those symptoms.  However, if
you pull back the stalk and get high beams but they go off when you
release then chances are its the switch itself.

Andre'
Lime Green 79
ICQ #76283458
http://mk1scirocco.com


koabi@email.arizona.edu wrote:
> 
> if i have my low beams on and i try to switch to high beams, the following
> occurs:  the high beams come on when i have the switch pressed down.  As
> soon as i let go, it doesn't stay on high beams, but instead low and highs
> go off completely.  When i try to switch again, the highs once again flash
> on when i have the switch pulled, and when i let go, the low beams come
> on, OR they all stay off.  Its inconsistent.  Fuses = good.  Relay problem?
>  or worse?
> 
> koabi
> 
> --
> Email LIST problems to: scirocco-l-probs@scirocco.org.
> To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org

--
Email LIST problems to: scirocco-l-probs@scirocco.org.
To unsubscibe send "unsubscribe scirocco-l" in the message to majordomo@scirocco.org