[tech] metal headgasket 2L 16v question

["Victor Farren" <vfarren@rrs.cdie.org>]

Sorry if this has been posted twice, but I sent it earlier and it didn't seem to go through.


My 2L 16v leaks at the back of the #1 cylinder even after replacing with brand new headgasket and new stretch bolts.  No surprise here, just annoyed.

I have heard that using the ARP head bolts will cure the problem.  They have been ordered.

I have also heard that using a metal headgasket can help solve the problem.  The thing is, when I asked the person who had done this, what kind of gasket they were using, they didn't know; said it was 'generic.'

Soooo, does anyone know which it is?  G60, A3 2.0L 8v (will the 8v gasket work on a 16v block?), other?  

I also don't want the gasket to increase the compression ratio as the head has already been shaved a little (.006 inch) and I might (praying I don't have to) have to deck the block if it turns out it is warped, which I doubt.

I have heard that just using the ARP head studs with the stock gasket is enough, but I am getting REAL tired of this damn leak and want to fix it once and for all.

thanks,

Victor



--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org