Re: coolant loss

[Brian McGarvey <brianm@zbt62.eastnet.gatech.edu>]

Dunno.
I get to pick my new one up on Wed.
My old mk1 did run a little warm. THe other option comes from ruynning go
fast motorcycles. If you are running too lean the motor will tend to heat
up. Running rich (fuel) will cause it to run cool. also the thermostats in
many cars are required for the proper back pressure and flow. As far as
the mk1 was concerned. the fan went out on it. So I couldnt sit in
traffic. had to be moving or it woudl over heat.


On Tue, 30 Jan 2001 james.david@clyde.com.sg wrote:

>
>
> thanks Brian - in fact I have removed the thermostat from my radiator system so
> now there is a constant flow - I am however intending to change the gauge
> although finding one in Singapore is another matter.  The radiator is completely
> new so does not need de-scaling although I did do that for my previous radiator
> (copper too) - the way that is done is to cut open the housing and run some kind
> of acid through the webbing. I get the impression that you run at much lower
> temperatures - what temperatures does yours normally reach??
>
>
>
>
> This is a dumb suggestion.
> Have you checked it you have good water flow?
> Simple things to check.
> Change your thermostat. (easy and cheap)
> try that. a partially stuck thermostat or one that doesnt open all the way
> could cause all kinds of problem. with coolant. And yes I have had every
> kind of problem dealing w. thermostats possible including getting a new
> one that was bad.(stuck shut in summer time in GA 100 deg F) not good made
> it about 5 mi then had to take it out on the road while the thing was
> still hot.(dodge van)
>
> If that doesnt work try a serious fluid flush. prestone makes kits that
> splice into the heater hose, you can get a piece of hose and disconnect
> one end and fake splice it in. Hopefully this would clear up any clogged
> water jackets.
>
> Water pump could be missing a couple of blades... I've had that problem
> too. got hot fast and never got cool.  This calls for an Remove and
> replace.
>
> Optionally it could be your gauge or sending unit.
>
> all else fails a replcement for the radiator could be in order...or
> possibly a descaling.
>
> Dont know if anyone out there knows how to descale a copper radiator. The
> copper radiator is bound to have some scale build-up cant remember if it
> would be more than AL but i belive so. Just look at the satute of
> Liberty... its green prolly alot like your radiator. (unless its new of
> course)
> anybody... im an EE not a ChemE so my knowledge of scale buildup is a
> little weak...
>
>
>
>
>
>
>  On Tue, 30 Jan 2001
> james.david@clyde.com.sg wrote:
>
> >
> > List,
> >
> > Thanks to all of you who responded with advice on my problem with coolant
> loss.
> > Thankfully, as it turned out, it was only  a small leak in the radiator
> webbing
> > - the hole was so small that escaping coolant evaporated immediately and was
> > difficult to spot. The hole was welded but after some time the leak sprang
> again
> > - As a result I decided to change the entire the entire radiator webbing
> (costs
> > me a bit!) - The radiator is made of copper whereas stock rocco radiators are
> > aluminium.
> >
> > In a country where the general atmosphere temp is 33 deg C, I now run the
> > following:
> >
> > - normal town running: 90 deg F
> > - highway running at around 50mph to 60mph: 100deg F
> > - highway running anything higher than 60mph: the temp increases above 100deg
> F
> > the faster I go.
> >
> > I read somewhere (I think in the Haynes manual) that the normal operating temp
> > as specified by Vw is 98 deg F - does anyone know if that is correct - I know
> a
> > lot of you out there run at temperatures much higher.
> >
> > I have always had some cooling problems with the car since I first bought it 1
> > year ago - for the first time it now all works properly and I took it up to
> > about 130 kph - however the rpm at this speed is about 4300 which I think is
> > excessive.  I am now desperate to get the .75 5th gear conversion kit ( I run
> > the FM gearbox) - Potterman only had half the kit in stock - so I suppose I
> now
> > have to go to Autotech direct - does anyone know somebody at Autotech and be
> > kind enough to call them to see if they would be willing to courier the kit by
> > air to Singapore? thanks a lot
> >
> > James
> >
>
>
>
>
>


--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org