RE: Hone a US 16v intake manifold to 50mm???

["Shannon Fenton" <sfenton@amazon.com>]

I pretty sure youll pay more than 400 bucks to have your manifold Extrude
Honed.


Thank you for your time.
Shannon Fenton
Telecom Resource Management
Amazon.com
206.266.6736
sfenton@amazon.com

> -----Original Message-----
> From: owner-scirocco-l@scirocco.org
> [mailto:owner-scirocco-l@scirocco.org]On Behalf Of Victor Farren
> Sent: Thursday, September 14, 2000 7:42 AM
> To: scirocco-l@scirocco.org
> Subject: Hone a US 16v intake manifold to 50mm???
>
>
> Anybody done this?  Is there enough material in a US 16v intake
> manifold to hone it out to 50mm?  Would Extrude honing work?  Paying
> $400+ for a euro manifold is just not in the picture right now (even
> if I could find one).
>
> Victor
>
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org