Setting CIS fuel mixture

[EuroVWtek@aol.com]

Dear List,

    I went to set up my fuel mixture on my 85 8v and I found that the 
anti-tampering plug was still stuck in the hole where the 3mm allen bolt is. 
So then, I did as the Bentley said and drilled a 3/32 in. hold into the 
aluminum only;not the hard steel bottom, and then I threaded in a sheet metal 
screw which is supposed to be used to extract the plug with. Well, after 
getting the screw in there, I then proceeded to pull straight up on the screw 
head with pliars. The plug did NOT want to budge. Finally after more vigorous 
pulling, the screw ripped out of the soft aluminum and now I am afraid I have 
too little aluminum left to be able to get another screw to bite in there. 
HELP! Hasa ny one else had to get one of these out? If so, did you encounter 
the same problem? Your time and help is much appreciated.

Thanks,

Tim Fritz

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org