Re: Air/Fuel guage

[Brett Van Sprewenburg <brett@netacc.net>]

>  I just installed one on my 16v tonight...by Autometer...neat guage.
>It would probably be an even more impressive guage if I knew that it
>was actually giving me correct readings!  : )
>  Has anyone installed one of these before?  (Shawn?)
>I just want to make sure that I hooked the guage up properly.  The main
>issue with this wiring is tapping into the O2 sensor.  Since the sensor
>produces such a small voltage I wasn't sure if I could just splice and
>solder the guage connection to the main O2 sensor wire...would this
>disrupt the signal enough to cause a problem?


I've heard that this is the right way to do it, but you're right, it
might be disruptive if you don't make good connections.

> Would I need to run a
>second O2 sensor to run just the guage itself?

This is the best way if you can figure out a way to do it.

>  Any experience or help is appreciated!  TIA
>
>=====
>____________________________________
>Benjamin Harder

==Brett

 \/  '84 Scirocco (ITB racer 2B) | "Hot VW's, take two home. They're small"
\/\/ '88 Scirocco 16v (Show), '92 Passat 16v (Winter+) | - brett@netacc.net

--
Email LIST problems to: scirocco-l-probs@scirocco.org. To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org