Re: caliper pistons

[Goethfaust@aol.com]

In a message dated 05/22/2000 7:30:53 AM Eastern Daylight Time, 
ewanhopkins@hotmail.com writes:

<< What exactly do you need the 12mm hex bit for? I've only ever needed an 
8mm 
 bit for the two piston housing bolts.
  >>

To retract the piston by screwing it in (clockwise).  You have to do this 
when you put on new pads.  What method did you use?

Greg F.

88 16v Scirocco DSP
87 GLi
86 Jetta 2-dr "GLi"
91 GLi
53 Huson Jet (uh)

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org