Re: tool needed ASAP(&Any interest in 4 pack of triple squares?)

[John Worden <scirocco@powerlink.net>]

At 12:30 PM 05/15/2000 -0400, doug c. wrote:
>i'm in need of the special tool that is used to get the hubcap off the
stock teardrop rims on the 16v rocco...for some reason the PO didn't have
it, and i need to fairly quickly so i can hopefully get on my new
bilsteins+H&Rs, a new caliper and pads, and then get it all inspected and
registered in time for the Ohio list meet.  I was just wondering if anyone
has an extra one laying around for some reason that they they wouldn't mind
getting rid of...TIA
>
you can use the 6mm hex bit, or allen wrench, on these.  Just be careful
and go slow.  I've done it this way and it does work, but the triple
squares are still the best way to go.   I've been auctioning off sets of
triple squares(6,8,10&12mm) on eBay lately.  If there is any interest from
the list I will consider getting some more for listers.  They would
probably cost around $7-8 delivered in the US.


John Worden
Wayne, Maine
ICQ 1527476
'81 MkI w/2.0 16V (waiting for the spring)		
'86 MkII 8V  (also waiting for the spring)
'98 Dodge Dakota 4x4
Later this year:
'75 wife and her
'98 Neon R/T
'87 Cherokee

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org