RE: Bad rod bearing?

["Shannon Fenton" <sfenton@amazon.com>]

Or you can check for end play by pulling/pushing on the crank pully...

-----Original Message-----
From: owner-scirocco-l@scirocco.org
[mailto:owner-scirocco-l@scirocco.org]On Behalf Of UrGTI@aol.com
Sent: Tuesday, May 09, 2000 11:11 AM
To: jonas85k@hotmail.com; scirocco-l@scirocco.org
Subject: Re: Bad rod bearing?


When you had the pan off you could have checked the play in the rods at the
crank.
The two rod knocking motors I have seen you could grab the rod and move it
forward and back (perpindicular) to the crank and make it knock on your own
.

Dont know about just swapping out bearings never done that or had a "new"
motor .

Jasin
16v S

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org