Re: rack boot

["Gerry Reichelt" <greichelt@mmcable.com>]

   If the inner tie rod is still connected, how do you spin the outer one on
the threads without disconnecting it from the carrier?
   Gerry
----- Original Message -----
From: <thescirocco@juno.com>

> I leave the outer tie rod attached to the hub carrier, unless I'm
> replacing it.
> Separate the outer tie rod from the inner rod, and mark where it should
> go back, and then replace the boot and bolt up the tie rods in the same
> position.
>
> Btw, an alignment is a good idea after having the tie rods apart.
> Peter



--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org