[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
oil pressure ?
today i started to install an oil pressure gauge in my 87 16v....i thought
i swapped the sensor that was in teh back to the front (on top of the oil
cooler) and then put in the dual pole sender for the gauge (in the
front).....when i started the car the oil light was blinking and would buzz
until higher rpms were reached.....when i swapped the wires for the 2
sensors the light was still blinking, but would the buzzer didn't go off
anymore......i am almost positive i have the correct dual sender, but would
a low pressure sender cause the light to blink?.....is there a specific
connection on the sender that the light in the dash must connect to and the
other is supposed to go to the gauge?..........i haven't hooked up the
gauge yet, so i'm not sure of the readings....would an incomplete circuit
like this cause the light to blink?.....
dave
--
Email problems to: scirocco-l-probs@scirocco.org To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org