Re: installing rear transmisison mount

[Eric L Ellis <elf16v@juno.com>]

If you haven't unbolted the "side mounts", why are you jacking the
bellhousing up? Perhaps some better descriptions will help us help you.

Eric
Good, bad....I'm the guy with the gun!


On Sun, 25 Jun 2000 16:59:37 EDT WaspHwy@aol.com writes:
> I am replacing the front and rear motor/tranny mounts and have run 
> into a 
> problem. when I jack up the rear of the bellhousing for the trans, I 
> can 
> slide the mount right it. but when I go to lower it, the top two 
> bolts stop 
> the trans from lowering into the right position. does this make 
> sense to 
> anyone? 

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org