[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: 1.8 to 2.0 conversion

To: "Jake" <maalouf@eng.buffalo.edu>, "Scirocco Group" <scirocco-l@scirocco.org>
Subject: Re: 1.8 to 2.0 conversion
From: "Craig Williams" <roccolister@hotmail.com>
Date: Mon, 5 Jun 2000 08:37:43 -0700
References: <Pine.GSO.4.05.10006031737540.29499-100000@ming.eng.buffalo.edu>
Reply-To: "Craig Williams" <roccolister@hotmail.com>
Sender: owner-scirocco-l@scirocco.org

Jake, if you bought a short block in good condition, this is all you need to
do.

Good luck -- Craig
----- Original Message -----
> I was thinking of just getting a short block with all of the pistons, etc
> already in it and then slapping my newly rebuilt 1.8 16V head on top of
> it, then dropping it into the car.  Any advice would be greatly
> appreciated.


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org

References:
- 1.8 to 2.0 conversion
  - From: Jake <maalouf@eng.buffalo.edu>

Prev by Date: Fwd: Clutch Problems 1981 MK1
Next by Date: tranny wanted
Prev by thread: Re: 1.8 to 2.0 conversion
Next by thread: RE: 1.8 to 2.0 conversion
Index(es):
- Date
- Thread