Re: Question re.Sensor Plate Pivot Arm

[thescirocco@juno.com]

On Sun, 27 Feb 2000 16:48:44 EST FiFoBum@aol.com writes:
>I believe the plate is 'spose to move freely up and down,
> but I noticed that the pivot arm had a little resistance upward 
> (flip over and push down). After I monkey'd with it (tech term), it no
longer had any resistance.
> Did I f*#k it up or just loosen a little dirt, oil & grime?
> Thanks for the input (or flames)
> Rob / Cincinnati
> "Student of the "roc"  
 
It is supposed to move freely, you probably knocked some dirt or grime
loose.

Peter
'79 Scirocco 16V project car
'80 Scirocco
'88 Scirocco 16V
'83 GTI, daily driver                                                    
                                                                         
                                                                         
              To reply to the Scirocco list click here:
<mailto:thescirocco@juno.com,scirocco-l@scirocco.org>

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk!  For your FREE software, visit:
http://dl.www.juno.com/get/tagj.

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org