90 to 100mm cv conversion help

["Ryan Schuermann"<rts@nol.net>]

ok..car is an 81s, tranny is out of an 87 16v. I need
to go from 90mm flange to 100mm to match up to the tranny.
whats the best way to do this? can i just order 100mm
inner cv joints and install them on the existing axels? or
should i pick up a set of complete 16v axels w/ cv joints?
will a 16v axel shaft mate up to my 81's hubs or whatever?

i'm going to putting a lot of power to these axels so i'm
kinda looking for the beefiest setup, as long as were not
talking thousands of dollars.

oh and my p/p 5angle valve job w/ new valve guide seals and
g-grind cam 1.7l head is for sale. I may throw it on ebay
if i don't get any reasonable offers. does anyone know if this
head matches up to any early  1.8l 8v?

Ryan

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org