[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Got the panel in!! (and a question on gauge wiring)



Hey all.
First of all, much love to Greg Davis of GAK Motorsports,
www.driversfound.com.  I got my 3 gauge panel a couple weeks ago, and I
took to installing it today.  Got it all in and stuff, and it looks
great!!
I have my bar-o-meter, my volt meter and my oil temp gauge in, but alas,
I don't have my dual-output sender yet for the oil pressure, so for now
I just have my volts and oil temp hooked up.  I also found out that all
of the bulbs I got with the wiring harness (from a 4000) were all bad,
and I blew my temp light, so I have no lights on my 3 gauges.  Once I
get new bulbs and my pressure sender, I'll be all happy!!  One question,
though.  On the harness I got, there is a wire running from the sensor
input to the light bulb.  Does the incoming signal need to be grounded
as well?  I just thought (possibly wrongly) that the signal just needed
an input.  I guess what I'm asking is, when I get my pressure sender, do
I need to ground the signal input as well as the gauge itself?
Oh, and good job on the Treffen page, Jim.  My car really looks good!!
=o)
Nate
(almost) Fully gauge-a-fied 84 8v


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org