RE: Help!!!! Sparkplug Question!!

[Gary Huff <ghuff@htech.com>]

Use a 5/8" rubber-on-the-inside-o-god-of-spark-plug-sockets craftsman, with
like a 50ft. extension :) Make sure its a damn good socket, be careful, and
dont crank them back in too hard. I shudder to think of the $$$$ repair
possibilities of locking a plug in a 16v motor! Thanks,
					Gary Huff

P.S. OEM uses NGK's for the 16v, I use them, and have no complaints.
($2.50-$3.00 each)

-----Original Message-----
From: Elias Glavinas [mailto:eg1@cec.wustl.edu]
Sent: Saturday, September 25, 1999 1:58 AM
To: Vaughn8v@aol.com
Cc: scirocco-l@scirocco.org
Subject: Re: Help!!!! Sparkplug Question!!



On this topic: what is the recommended spark plug for the 16V's? Platinum? 


Thanks,

Elias


On Fri, 24 Sep 1999 Vaughn8v@aol.com wrote:

> What the HELL size socket do I need to get down in there to get those
plugs 
> out?!?!?!?!?!?!?!  21mm!?!?!?!?  16v by the way.  All the sockets I have 
> tried are waaay to thick.
> 
> thanks
> 
> Ben
> 88 16v Scirocco
> 
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
> 
> 


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org

--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org