Re: [STEREO][Running mult. amps]

["Peterson/Doty" <bdoty@columbus.rr.com>]

<x-charset iso-8859-1>I don't know of any distribution blocks that take smaller than 8 gauge and
it's usually 1 or 4 gauge input with 8 gauge outputs.  Of course it all
depends on what your amps are rated at.  I run a 50x4 with two 30 amp fuses
in it on 8 gauge and ran my last one on 8 gauge also (65x2, 30 amp).  I'm
sure someone knows size/power info but it could be well worth it to run a
larger power wire rather than find out it's inadequate.  HTH

Jeremy
'86 16v
----- Original Message -----
From: Tyler Zachau <Pennyz@ieway.com>
To: <scirocco-l@scirocco.org>
Sent: Tuesday, October 26, 1999 11:09 PM
Subject: [STEREO][Running mult. amps]


> I just built a custom board to hold 2+ amps... question is, what is the
> best way to power both of them? I have 10 gauge wire running from the
> battery, but I havn't been able to find a power distro. block that accepts
> 10 gauge wire and I don't want to go down to 8 gauge wire because it was
> hard enough to run 10 as it is. Any ideas/suggestions here?
>
> ====================
> Tyler Zachau
> ICQ # 1357564
> tylerz@ieway.com
> 88 16v Scirocco
> --------------------
>
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org
>


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org


</x-charset>