Re: spring perches by ABD (ADB?) racing

[Neal Tovsen <ntovsen@piper.hamline.edu>]

So where could one acquire a set of these and how much do they cost? I
have a Koni/H&R setup that didn't lower the car as much as I thought it
would. Well, it *did*, but then I took teh US boat-anchors...er...bumpers
off and it went back up. The rear spring perches are set at the middle of
the Konis, so it sounds like I could use the ABD units to drop the front a
little and the lower Koni spring perches on the rear, right?

I don't need the car to be "slammed" which is why I didn't get coilovers,
but I've been wishing I had waited and spent the extra money. This sounds
like it would put me right where I want to be!

Neal


On Wed, 21 Jul 1999 XXSpArCoXx@aol.com wrote:

> 	The goal of these top hats is to level off cars after they have been 
> lowered. Or to go with bilstiens or konis that have threaded rears to get 
> both ends nice and low. The Hat is smaller so it you don't lose spring travel 
> but you loss shock travel. Only about half an inch or less. 
> Its amazing what half an inch dose to the aesthetics of a car.
> Later
> ~Danny~
> 
> --
> To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
> If you experience other problems, email: scirocco-l-probs@scirocco.org
> 
> 

			Neal Tovsen


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org