Re: Electronics/for euro lights

["Rich Zuk" <emt@imcnyc.com>]

Yes- this procedure is good.     However, where can I get new
tabs/connectors?  Since all the wiring will be "new", I do not want to
re-use these tabs.  New white tabs please.  Peace
Rich Z
>usually what I do when I have a connector and a wire that is too >thick to
fit..    >I strip the wire back a little further than I normall would.. say
1" or so  and then  I pull back a few of the strands until I get a good fit.
I then crimp the  connector and then solder the rest of the wire to the
connector housing itself.
>
>mark
>
>
>
>----- Original Message -----
>From: Andre' Bjorkheim <andreb@maxwell.ee.washington.edu>
>To: Rich Zuk <emt@imcnyc.com>
>Cc: Scirocco List <scirocco-l@scirocco.org>
>Sent: Sunday, February 14, 1999 10:53 PM
>Subject: Re: Electronics/for euro lights
>
>
>>> This may be overkill...but I will have
>>> 4 Bosch relays
>>> 4 in-line blade fuse holders with 15Amps in each
>>> all with...10gauge wire.
>>> I'm doing it once,  doing it right, no one is going to be looking in
>there,
>>> and running as many wires from contact to contact without splicing into
>it.
>>> By golly, I think I've got it.
>>
>>    Its all good, except for the part with the 10 gauge wire.  If you
>>use the
>>  stock type of female connector that goes in the white tab, 10 gauge
>>may be
>>  to large.  I use 12 gauge it can be a PITA to get it jammed in there.
>>Just
>>  something to ponder...  =p
>>
>>========================
>>
>> André
>> Lime Green 79 Scirocco ©
>> ICQ #266870
>>
>>--
>>To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
>>If you experience other problems, email: scirocco-l-probs@scirocco.org
>>
>>
>
>
>--
>To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
>If you experience other problems, email: scirocco-l-probs@scirocco.org
>


--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org